Recent content by Bubble300tdi

When i done the fronts with the self tappers i always said when i do the rears id use rivets as the suspension i put on that disco was reeeally flexy lol .. Im sure i chucked the sealing rubber in the back with everything else. How you getting on with her anyway ? I do miss her sometimes lol

Must say, in the year that i owned that truck i never had a problem with the central locking

Theyre on ebay, i have them in my watch list ready for payday

Does anyone know the standard boost pressure for a 300tdi disco? Cheers.

As above, its down to preference at the end of the day

As above, 2.0l 16v, full respray and new engine last year, sorned but mot'd till march '14. £1000 ONO .. Or swap for v8 landy

As said before, landys leak, period. Mines leaking from the rear crank seal, and im doing that this week while the engines out. My answer to the smoke is a service also, new glo plugs and air filter, or wack a straight through zorst on it, decat, de-egr and smile in a childish way as it smokes...

Iv been looking into prices, i have no idea whats what, so .. Ap driveline from paddocks is £78 inc vat. Borg & beck from fleabay is around £90 and an LuK from my local supplier is £101 inc vat. I just dont know which is better

So, replaced my suspected broken clutch slave yesterday, goes to bleed, and nothing ! Nothing at all. So, i decided right maybe the clutch arm had broken on the pivot point ... ENGINE OUT ! So as you can see, the arm was infact intact, but i shall wip it off and weld a plate...

I literally got my clutch out last night to investigate why it wasnt working, i removed the engine completely, lifted it up and towards the front, took approx 3 hours, my clutch is fubar'd though, the thrust bearing and melted onto the pressure plate. But, after doing what i did, i can see why a...

Hi all, my clutch pedal has dropped all the way to the floor, and i literally have an inch of travel to engage/open the clutch with .. Could this the release bearing ? Either way i think i need a new clutch, but a bit of advise would be appreciated ?

Thanks for the advice, ill give a look when i blank the egr off

So remove the lower hose and assuming theres gunk in it ill be able to tell .. Is that what you meant lol

Bottom hole ? Please elaborate ?

My egr is still functioning, but i bought a kit to blank it off on friday should be here this week, is worth doing it "just coz" when i blank off the egr then ?