no pressure when braking

sawneybean · Jan 28, 2014

Hi my freelander engine cut out and when I stared it again I now have no pressure on my brakes. I checked for fluid as the brake warning light came on topped up with fluid but still no pressure when braking. Any help appreciated

thanks

Optimus Prime · Jan 28, 2014

which engine do you have ?

just topping brake fluid isn't necessarily the answer as the light can come on for other reasons too.

sawneybean · Jan 28, 2014

its a td4

mjrimmer · Jan 28, 2014

If you have no pressure and your foot just goes to the floor...then you have a leak on the system somewhere.

sawneybean · Jan 28, 2014

I thought it was that, I will have a good look the next time its dry outside. although I may have to wait till July or August.lol

teddywood1 · Jan 28, 2014

or is it a case of it being very hard and almost will not stop ,if that is the case then it will be your vacuum pipe, that goes over the gear box it rubs on it,and you will find a hole in it

digby · Jan 29, 2014

could be an internal leak in the master cylinder - in this case there will be no fluid on the floor.............

check for fluid inside your wheels as it dribbles down from leaking calipers / cylinders

broken break pipes of course are a possibility

everton · Jan 29, 2014

had this problem kept topping up with fluid when the low level light came on. the fault was Brake pipes front to back on my td4 they travel side by side on the offside they were in a bad shape leaking fluid .cost me 145 total for 2 pipes front to back and 2 cylinders .fitted .

no pressure when braking

sawneybean

New Member

Optimus Prime

Well-Known Member

sawneybean

New Member

mjrimmer

Active Member

sawneybean

New Member

teddywood1

Well-Known Member

digby

Active Member

everton

Member

Similar threads