AliV

New Member

• Jun 25, 2012

• #1

Hello,

I purchased a very cheap winch where the previous owner had the bright idea to run it underwater for extended periods of time and now (surprise, surprise) it no longer works despite redoing the wiring and fitting a new solenoid.

Is it a simple task to take it apart, clear it up and put back together again? I cannot see any tutorials on how to do this anywhere.

Has anyone done this before? Is it advisable? Any tips? It can't be that difficult, surely?

Thanks

 

D

dellboy1959

Well-Known Member

• Jun 25, 2012

• #2

Never had one apart but it can't be that hard to do,after all it's only a geared electric motor.

 

wiltshire landyman

I’m back

• Jun 25, 2012

• #3

take the centre apeture out and check all copper contacts are clean,use electrical contact cleaner not wd40

 

S

Sean

Banned

• Jun 25, 2012

• #4

wiltshire landyman said:

take the centre armature out and check all copper contacts are clean,use electrical contact cleaner not wd40

Click to expand...

 

wiltshire landyman

I’m back

• Jun 25, 2012

• #5

make sure u have no high/low spots either emery paper will work well

 

S

Sean

Banned

• Jun 25, 2012

• #6

check none of the windings are open circuit before you get too involved, they tend to overheat and burn out - if they have you now have a new door stay

 

300tdistu

Well-Known Member

• Jun 26, 2012

• #7

Time to stop buying cheap crap lol

 

AliV

New Member

• Jun 26, 2012

• #8

300tdistu said:

Time to stop buying cheap crap lol

Click to expand...

I'll bear that in mind.

Thanks for your help everyone.

 

jai_landrover

Well-Known Member

• Jun 26, 2012

• #9

This may sound weird but I used to bed in my new DC motors under Fresh water in reverse to bed the brushes in and to slightly advance the timing of the fixed brushed motors used back in the day when RC car/boat racing pre brushless.

No doubt its not been in clean water. Check windings and if they check out a brush kit will most likley be needed or at least new springs. But be warned When I rebuilt my old Tmax Superwinch were trying to sting me for £100 for a brush set if you look around then they can be got much much cheaper.