hext

Active Member

• Jul 27, 2010

• #1

Hi All

I've just bought a winch bumper (standard non-aircon type)and after sitting it down in front of the 90, I think I may have issues fitting it.

My steering guard bolts to the inner edge of the chassis members (using the lashing points and a bolt that holds part of the steering assembly.
My new bumper also uses the front lashing points (as well as the standard bumper bolts)
This means I now have two 8-10mm poeces of metal that need to be in the same place.

This must be a fairly common problem, lots of people have winch bumpers AND steering guards fitted - What did you have to do to get them both to fit?

Man Thanks

Chay

(1995 300tdi 90)

 

V8_Disco

New Member

• Jul 27, 2010

• #2

is the steering guard a one piece or 3 piece?

 

Sirus

Your all Banned except me

• Jul 27, 2010

• #3

You need longer bolts. You may have to champher the ends of one of them to get them inside the other.

 

hext

Active Member

• Jul 27, 2010

• #4

3 piece, thanks!

 

V8_Disco

New Member

• Jul 27, 2010

• #5

hext said:

3 piece, thanks!

Click to expand...

if you got the bolts with the bumper then they are normally long enough to bolt both on, there might need to be a bit of fettling to fit the front plate of the guard on tho

 

hext

Active Member

• Aug 3, 2010

• #6

no joy it doesn't fit..
Went into the job all cocky with me new bolts and because the bracket fits on to the inner chassis rails and has a "lip" bit it seems to get in the way of the strenthening plates of the bumper..

back to square one...

 

Last edited: Aug 3, 2010

J

james_hillerby

New Member

• Aug 3, 2010

• #7

Would it be possible to take the steering guard apart and oval the holes in the front plate allowing you to move the brackets either inwards or outwards to miss the bumper?