V

virtualme123

New Member

• Jun 13, 2012

• #1

So I changed the clutch on my manual 2.5 DSE and obviously had the gearbox out (without breaking) gearbox from transfer box). Trouble is now I now can't select low range however before I had no problem. Any ideas what could have gone wrong?

Thanks

 

jamesmartin

Well-Known Member

• Jun 13, 2012

• #2

plugged motor and loom back in ,damaged motor

 

S

stopover

Active Member

• Jun 13, 2012

• #3

virtualme123 said:

So I changed the clutch on my manual 2.5 DSE and obviously had the gearbox out (without breaking) gearbox from transfer box). Trouble is now I now can't select low range however before I had no problem. Any ideas what could have gone wrong?

Thanks

Click to expand...

Did you forget to plug the transfer motor hi/low in?

 

Last edited: Jun 13, 2012

V

virtualme123

New Member

• Jun 13, 2012

• #4

Well I think it is just the big two black connectors that fit together and then attach to a metal clip. I double checked this connector and all looked good.

I heard about putting a 12v charge over it to see if it might be a duff motor...

 

Chrisfrain2007

Active Member

• Jun 13, 2012

• #5

Does it ask you to select neutral on the message centre?

 

V

virtualme123

New Member

• Jun 14, 2012

• #6

No neutral message, had that before and realised I had that transfer box fuse in for towing

 

Chrisfrain2007

Active Member

• Jun 14, 2012

• #7

Mine won't go into low unless I have it in reverse, either the switch is fubar or its been linked to the reverse switch, does the Orange light on the dash flash when you push the button?

 

V

virtualme123

New Member

• Jun 14, 2012

• #8

Yeah I get flashing from the button and on the dash gears with a cross through it flash then got out, can't remember what it used to do when it worked to be honest...

 

Chrisfrain2007

Active Member

• Jun 14, 2012

• #9

The Orange light flashes as it moves from high to low, doesn't beep or anything but then briefly shows low on the message centre