jwaldron said:

my spare is loose anyway as the holder part has come off... anyone make then (it will need welding into the boot floor) as I have a hole!

Click to expand...

the hooded claw said:

DO NOT buy a "Spare wheel holder" ...go to the local Builders merchant & buy a length of 6mm threaded bar (Comes in 1 metre lengths) 2 Nuts & a hand ful of washers ..+ bout 1 metre of 4mm ply board

Thread the bar up thru the hole, measure & cut...... nut & washers on the end (Under the car) nut & washers inside car (at bottom of Wheel well) place wheel over bar sticking up, cut ply to same width as wheel & drill a hole in it at the centre place ply on threaded bar down to top of spare wheel washers & nut to tighten.....

SORTED!!!!!!!!!!!!!

Totalr cost ..Bout 6 quid

Click to expand...

the hooded claw said:

DO NOT buy a "Spare wheel holder" ...go to the local Builders merchant & buy a length of 6mm threaded bar (Comes in 1 metre lengths) 2 Nuts & a hand ful of washers ..+ bout 1 metre of 4mm ply board

Thread the bar up thru the hole, measure & cut...... nut & washers on the end (Under the car) nut & washers inside car (at bottom of Wheel well) place wheel over bar sticking up, cut ply to same width as wheel & drill a hole in it at the centre place ply on threaded bar down to top of spare wheel washers & nut to tighten.....

SORTED!!!!!!!!!!!!!

Totalr cost ..Bout 6 quid

Click to expand...

redhand said:

What if his butler is ****e at DIY?? or refuses to get his hands dirty???

Click to expand...