Dr_evil
Banned
Discovery to defender gearbox convertor, simple enough if you have a lathe. This is it about 50% complete, two of the three lips are turned and then it needs a hole drilling and tapping along with a 5/8th hole in either end with a 3/4" solid in the to separate them
Started life as a 50mm bar and turned to the correct diameter
I'll make a separate thread detailing it incase anyone needs to search in the future but I used some pinched designs (essentially going to compound the info)
Started life as a 50mm bar and turned to the correct diameter
I'll make a separate thread detailing it incase anyone needs to search in the future but I used some pinched designs (essentially going to compound the info)



