davidmayo · Aug 18, 2013

Replacing 110 200tdi bulkhead and need someone to have a look at theirs. On the engine bay side of the bulkhead there are 3 grommets either side for wires etc to go to the dash. What goes through these?

Beneagles · Aug 18, 2013

Speedocable in the middle... heater control cables towards the n/s...and aselection of wires through the o/s.

davidmayo · Aug 18, 2013

Thanks, anything through the 3 holes on the passenger side?

Also on the drivers side I take it the heater wire both go though te same hole

Beneagles · Aug 18, 2013

Offhand... the pipes and wires for the washers...
Yes - they do on mine certainly.

gse1986 · Aug 18, 2013

Beneagles said:
Offhand... the pipes and wires for the washers...
Yes - they do on mine certainly.

On mine there's seperate very small holes for the washer stuff

davidmayo · Aug 18, 2013

My washer pipes etc go though smaller holes a bit lower down, directly above the footwell.

Is this the same as yours.

Like the 3 grommet holes on te drivers side there is 3 holes in the identical e place but on the passenger side. What are these used for?

dogsbody · Aug 18, 2013

davidmayo said:
My washer pipes etc go though smaller holes a bit lower down, directly above the footwell.

Is this the same as yours.

Like the 3 grommet holes on te drivers side there is 3 holes in the identical e place but on the passenger side. What are these used for?

You haven't got holes suitable for it to be right or left hand drive have you?

davidmayo · Aug 18, 2013

That could be the case but there was definatly something through it before I changed it all. Haha.

Here is a pic, you can see I have put in the wires ect on drivers side but there is the same on the passenger side

mostin58 · Aug 18, 2013

i have a bulkhead that is off the landy for refurbing with everything still attached, and i have a hose for windscreen washer through passenger side and a lead that goes to the heater fan. if you want a pic pm me and i will email it you.

the_wolf · Aug 18, 2013

mostin58 said:
i have a bulkhead that is off the landy for refurbing with everything still attached, and i have a hose for windscreen washer through passenger side and a lead that goes to the heater fan. if you want a pic pm me and i will email it you.

Yup same here but I do have the same holes as on the drivers side so it can be flipped to lhd. I thought they all had the ability to be switched over easily? My bulkhead holes are blanked off with some frosted plastic with just some small rubber grommets through them for heater cable and washer jet

davidmayo

Active Member

Beneagles

Well-Known Member

davidmayo

Active Member

Beneagles

Well-Known Member

gse1986

Active Member

davidmayo

Active Member

dogsbody

Very senior member

davidmayo

Active Member

Attachments

mostin58

Active Member

the_wolf

Well-Known Member

Similar threads