[davidmayo]

Replacing 110 200tdi bulkhead and need someone to have a look at theirs. On the engine bay side of the bulkhead there are 3 grommets either side for wires etc to go to the dash. What goes through these?

 

[Beneagles]

Speedocable in the middle... heater control cables towards the n/s...and aselection of wires through the o/s.

 

[davidmayo]

Thanks, anything through the 3 holes on the passenger side?

Also on the drivers side I take it the heater wire both go though te same hole

 

[Beneagles]

Offhand... the pipes and wires for the washers...
Yes - they do on mine certainly.

 

[gse1986]

Offhand... the pipes and wires for the washers...
Yes - they do on mine certainly.

On mine there's seperate very small holes for the washer stuff

 

[davidmayo]

My washer pipes etc go though smaller holes a bit lower down, directly above the footwell.

Is this the same as yours.

Like the 3 grommet holes on te drivers side there is 3 holes in the identical e place but on the passenger side. What are these used for?

 

[dogsbody]

My washer pipes etc go though smaller holes a bit lower down, directly above the footwell.

Is this the same as yours.

Like the 3 grommet holes on te drivers side there is 3 holes in the identical e place but on the passenger side. What are these used for?

You haven't got holes suitable for it to be right or left hand drive have you?

 

[davidmayo]

That could be the case but there was definatly something through it before I changed it all. Haha.

Here is a pic, you can see I have put in the wires ect on drivers side but there is the same on the passenger side

 

[mostin58]

i have a bulkhead that is off the landy for refurbing with everything still attached, and i have a hose for windscreen washer through passenger side and a lead that goes to the heater fan. if you want a pic pm me and i will email it you.

 

[the_wolf]

i have a bulkhead that is off the landy for refurbing with everything still attached, and i have a hose for windscreen washer through passenger side and a lead that goes to the heater fan. if you want a pic pm me and i will email it you.

Yup same here but I do have the same holes as on the drivers side so it can be flipped to lhd. I thought they all had the ability to be switched over easily? My bulkhead holes are blanked off with some frosted plastic with just some small rubber grommets through them for heater cable and washer jet