This is a question for Datatek, having finally completed my engine swap in my 96 2.5 dse, i'm now sorting out all the little snagging bits before i put it back on the road after an overheating issue killed the previous engine, iv'e fitted Datatek's cooling fan mod and set it up as per the instructions (followed to the letter, makes a change for me!) the fans cut in perfectly just after the temp reaches 90 degrees measured on the top hose where the sensor has been placed, but the fans then seem to run for ever and the temp drops right down to 40 degrees or there about's before they even think about cutting out, the temp gauge on the dash moves back down into the blue zone, this seems excessive and as i'm now paranoid about anything to do with the cooling system i want to get this set up properly before i actually start using it again, have i done any thing wrong or is it a component problem? all info gratefully received.


