overlandrover
New Member
on what?
overlandrover
New Member
From RAVE
Refit
23. Ensure mating faces are clean.
24. Apply a thin bead of Loctite Superflex (black)
sealant to 4 notches between cylinder head and
block.
25. Position new gasket seals. Ensure ends engage
correctly in notches.
26. Fit new inlet manifold gasket.
27. Position manifold gasket clamps. Fit bolts and
tighten to 0.7 Nm (0.5 lbf.ft).
28. With assistance to hold harness and ignition
coils aside, position inlet manifold assembly.
NOTE: When fitting inlet manifold bolts,
tighten in reverse of removal sequence.
29. Fit inlet manifold bolts. Initially tighten to 10 Nm
(7 lbf.ft)
30. Finally tighten bolts to 50 Nm (37 lbf.ft).
31. Tighten gasket clamp bolts to 17 Nm (13 lbf.ft).
Refit
23. Ensure mating faces are clean.
24. Apply a thin bead of Loctite Superflex (black)
sealant to 4 notches between cylinder head and
block.
25. Position new gasket seals. Ensure ends engage
correctly in notches.
26. Fit new inlet manifold gasket.
27. Position manifold gasket clamps. Fit bolts and
tighten to 0.7 Nm (0.5 lbf.ft).
28. With assistance to hold harness and ignition
coils aside, position inlet manifold assembly.
NOTE: When fitting inlet manifold bolts,
tighten in reverse of removal sequence.
29. Fit inlet manifold bolts. Initially tighten to 10 Nm
(7 lbf.ft)
30. Finally tighten bolts to 50 Nm (37 lbf.ft).
31. Tighten gasket clamp bolts to 17 Nm (13 lbf.ft).
