shaunm41 said:
I did try that and there was a noticeable difference with the maf disconnected. It was worse.
Click to expand...
Check the EGR valve is fully closed and not stuck and remove the vacuum pipe from it.
A duff MAF can and does affect low end performance, there are rolling road graphs showing the effect of a duff MAF against the MAF signal.
 
Back to this issue, very slow take off and stalling when moved into drive or reverse.

Could this be related to low gearbox oil?

Noticed I have a leak on both ends on one of the rubber pipes to the oil cooler.
 
shaunm41 said:
Back to this issue, very slow take off and stalling when moved into drive or reverse.

Could this be related to low gearbox oil?

Noticed I have a leak on both ends on one of the rubber pipes to the oil cooler.
Click to expand...

It could be related to the injection pump being knackered.
 
Could be but I'm hoping not as I don't fancy buying another one of those. Had a quote of £600 to have it reconditioned
 
shaunm41 said:
Could be but I'm hoping not as I don't fancy buying another one of those. Had a quote of £600 to have it reconditioned
Click to expand...

About the going rate i am afraid unless you can get one trade. Rap that around your starting problems and i think it's a fair conclusion. Does the Nano show any EDC fault codes? Like fuel flow out of range or anything like that.
 
I fear you may be right mate.. No faults coming up. I will post some screen shots of the some of the info relating to the edc tomorrow. I posted this the other day dunno if you can tell anything from it?

savujaqy.jpg
 
shaunm41 said:
Just been on a trip to Blackpool about 80 mile each way without a glitch, got almost home and was driving down a hill in drive and the engine cut out and gearbox fault came up on the display. Knocked it in to neutral straight away and rolled on to a safe place to stop... Moved into park then re started and carried on like nowt has happened...

Is it heading for a Costly repair or could it be something simple?

It's a 2000 (x) DHSE auto....

Thanks

Shaun
Click to expand...

Bit late onto this thread but I've got the same car with the same, very intermittent, fault. On mine it seems to happen on a downhill bend. I've discounted the 'gearbox fault' as I'm now convinced that it's just the first fault to be displayed when the engine cuts out. In the years I've had the car it's happened maybe six times but never when I've got diagnostics to hand.
I'd like to get to the bottom of it but I can't prove what it is and I'm not going to throw money at it. My thoughts are; worn FIP stop or crank sensor but I even wonder if it could be an electronic thing between engine and gearbox.

As I say though it's so intermittent that I'm not willing to spend money on guesses and just gently feather the throttle if I think that the road conditions are likely to cause it.
 
I have the same problem and i think that if on the overrun the edc cuts all fuel to the injectors to assist engine braking but when the speed gets below a certain speed and the gearbox tries to change into a lower gear the engine stalls and the gearbox goes into neutral and a gearbox fault comes up. nanacom does not pick up any fault.the only cure i know is to put gear selector in to position 3 for long downhill decent.
Dont know if anyone can understand my reasoning or even know what im talking about
 
ovalandrover said:
I have the same problem and i think that if on the overrun the edc cuts all fuel to the injectors to assist engine braking but when the speed gets below a certain speed and the gearbox tries to change into a lower gear the engine stalls and the gearbox goes into neutral and a gearbox fault comes up. nanacom does not pick up any fault.the only cure i know is to put gear selector in to position 3 for long downhill decent.
Dont know if anyone can understand my reasoning or even know what im talking about
Click to expand...
They stall in that situation when the torque convertor unlocks and the engine revs drop to idle. A worn stop in the FIP seems likely, or the crank sensor so when the needle lift sensor stops sending on the overrun the EDC thinks the engine has stopped and shuts down.
 
Just drove 150 mile round trip towing empty trailer there and then back with another RR on the trailer. No problems untill I got within a mile of home. Stalled twice at lights. Very low on power running like a bag of ****. One set of lights it almost stalled so I knocked it in to neutral and it idled at around 600rpm and would not rev at all. Just sat there for a good 3-4 mins then all was ok again.
 
shaunm41 said:
Just drove 150 mile round trip towing empty trailer there and then back with another RR on the trailer. No problems untill I got within a mile of home. Stalled twice at lights. Very low on power running like a bag of ****. One set of lights it almost stalled so I knocked it in to neutral and it idled at around 600rpm and would not rev at all. Just sat there for a good 3-4 mins then all was ok again.
Click to expand...
Maybe there is still **** in the fuel in the FIP and the tank.
 
Anyone got a link where I can buy one from? Gotta be worth a shot. It may help my starting issues which today have been no better even with hot start fix
 
It's low on fuel now so might drop tank and change pump just to see if its any better... This donor car is running sweet... For a 175000 miler... No hot start fix or anything and starts perfectly hot or cold.... I parked mine up and been using that all evening.
 
There is a method where you cut the boot floor to get to the top of the tank....easier than dropping the tank, plus once you have done it, next time you have to do it, you just unbolt the little hatch you cut rather have to drop the tank again!

Search for it...real good walkthrough and a measured template to follow also!
 
Thought he had done the fuel flow test and it was fine. Or have i lost the plot?
 
wammers said:
Thought he had done the fuel flow test and it was fine. Or have i lost the plot?
Click to expand...
He did I believe (in his other thread), but that was with a full tnak I think...he has mentioned his issues are when the Fuel Light is on...so assuming the in tank pump is getting weak when running low on motion potion!
 
You must log in or register to reply here.

Similar threads

K
L322 Seeking help - Gearbox Fault
Replies
7
Views
770
KCTippi
K
R
L322 gearbox problem 2010 TDV8 Vogue
Replies
15
Views
2K
roythebus
R
kermit_rr
L322 ZF8HP70 gearbox problem
2 3 4
Replies
79
Views
6K
arpa
A
Paul Coddington
P38A Viscous coupling
2
Replies
23
Views
2K
Mark Piercy
Mark Piercy
feyniriel
Gearbox fault P38?
Replies
3
Views
1K
Grrrrrr
Grrrrrr