Hicap phill
Well-Known Member
My 110 level is on the filler side.(may be a later RRC I swapped out)
What about prc3098
Do you have the pick up & return on the top or the tank?
What about prc3098
Do you have the pick up & return on the top or the tank?
Seaswood
Active Member
Prc3098 does not have a fuel fitting as part of sender?
Top of tank is sealed this is L side.
I am in process of replacing fuel lines but there are several into tank small lines on sides.
Next is to identify each of those & verify I have each for replacement.
Yes this tank was replaced when I removed tank the forward fitting basically fell apart.
So correct or not but wiring is on left also.
Thnx
Top of tank is sealed this is L side.
I am in process of replacing fuel lines but there are several into tank small lines on sides.
Next is to identify each of those & verify I have each for replacement.
Yes this tank was replaced when I removed tank the forward fitting basically fell apart.
So correct or not but wiring is on left also.
Thnx
Hicap phill
Well-Known Member
Take a photo of tank & sender. May jog my brain cell
Seaswood
Active Member
Do not know if this is same as original but the original lines are there with many band aids seem to be correct.
I will find out as I replace them, the return is fwd of fill. That is fuel level unit as they do fail best to try to get new one?
Tank was cleaned inside with cleaner as was tank level unit.
I will find out as I replace them, the return is fwd of fill. That is fuel level unit as they do fail best to try to get new one?
Tank was cleaned inside with cleaner as was tank level unit.
Hicap phill
Well-Known Member
I have seen that part on the bay last night.
When I’m parked up later will have a look again
It looked like only 1 pipe connection though.
Does yours have the 2? Flow pick up & return?
O
Seaswood
Active Member
The pickup is through the level unit, the return is fwd right side of the fill, then over flow next to fill.
I am also adding a sedimenter on left next to the pickup level unit.
Fiche does show the sedimenter on left there is a spot on frame to bolt it there.
Then there are many fuel tank configurations gas & diesel.
As time allows I am changing out fuel lines installing the sedimenter.
I am also adding a sedimenter on left next to the pickup level unit.
Fiche does show the sedimenter on left there is a spot on frame to bolt it there.
Then there are many fuel tank configurations gas & diesel.
As time allows I am changing out fuel lines installing the sedimenter.
Hicap phill
Well-Known Member
Spotted these.they both look like yours.
the sedimenter is off a disco but not looked for 1 of them. They normally corroded & fail so I removed mine.
You can get a gauze fitting on the end of the pick up
the sedimenter is off a disco but not looked for 1 of them. They normally corroded & fail so I removed mine.
You can get a gauze fitting on the end of the pick up
