[nickh75]

just been looking on paddocks site and found jackable sills for my disco,
only thing is i dont know much about em
so here goes, do they replace the inner and outter sill or do they just bolt on abit like a side step, eg do ya weld em in or do ya fix em to the out rigger.
thanx in advance
an sorry if this is a daft post

 

[nickh75]

well! take it you lot know jack all about sills then by the floods of reply's i got

 

[nickh75]

ok! i'll take the hint an ask the shop

 

[Pikey]

hahaha. I think they bolt on.

 

[nickh75]

hahaha. I think they bolt on.

do thay replace the inner and outter sill?
coz mine are rusted and it would be better when i go greenlaneing
and thanx for the reply red

 

[Pikey]

No they're just strong side steps. If you want strong sills/sliders cut the old sills off and weld in a length of 40x100mm box section instant sills and sliders.

 

[nickh75]

No they're just strong side steps. If you want strong sills/sliders cut the old sills off and weld in a length of 40x100mm box section instant sills and sliders.

nice one
thanx red

 

[shanelloyd]

My Rock Sliders Bolted Onto The Outriggers And I Did Not Have To Do Any Drilling At All. 1/2 Hr Job On Each Side Thats All.
Shane

 

[BandM]

I dun know, sos can't answer

 

[david451]

My Rock Sliders Bolted Onto The Outriggers And I Did Not Have To Do Any Drilling At All. 1/2 Hr Job On Each Side Thats All.
Shane

Are you able to post some pics, I have side steps and they are a menace, was going to make some.

 

[Pikey]

Their just a length of box section with a length of tube at one end and a pair of flat plates at the other end, with an hole drilled through em.