[mudmut]

I need to replace the n/s/f outer wing section and repair the top and headlamp sections. How easy or hard is it to do in situe as I will need to straighten the other bits with a slide hammer and this will be easier with it still bolted to the motor.
Cheers

 

[kevstar]

PITA do to it in place unless you've got girls arms lol

 

[mudmut]

PITA do to it in place unless you've got girls arms lol

Far from it, might cut the old one off, hopefully get to the bolts easier

 

[Al2O3]

Far from it, might cut the old one off, hopefully get to the bolts easier

The bolts aren't that difficult. You'll need an extension bar and a half on the socket and probably a UV joint. And a torch

 

[philsefo]

I did one side with in in place, took ages and ended up cutting the old one to pieces. For the other side i just took the wing off, much easier!!

But yeah you do need an extension bar and some patients

 

[mudmut]

Fitted a complete new wing in the end, managed to pick up a genuine Land Rover top section for peanuts so right result there. Wasn't too bad a job to do in the end just a bit fiddly

 

[nobber]

That looks great, well done.

 

[mudmut]

That looks great, well done.

I'm quite pleased with it for a rattle can job