Search results

I don't think I've seen this covered, so here goes. Because I don't use my range very often ( maybe once a fortnight ), I'm always getting a flat battery . Question 1, is that about right for the time involved ? Question 2, I've bought one of those solar top up chargers that sit on the dash...

I. Want to buy a nano com from bbs. I'm not sure which one I need. I have a '96 4.6 hse auto petrol. Can someone please enlighten me. Thanks and merry christmas.

hi guys, recently refurbished my pump and valve block. then had a o ring stuck under the diaphram. all now seemed to be working. rises to all hights fine, storage side is fine. here's the problem, the pump keeps cutting in and out, it runs for maybe 20 seconds in which time the front rises about...

Just a quick update. my eas diaphram wasn't sealing, except when i put my finger over the exposed exhaust port for a few seconds. you nice chaps suggested a strip and look see, and what i found amazed me. no, not a little gremlin but poking out of the little brass tube beneath the diaphram was...

While following how to eas, I removed the exhaust filter while the pump was running. Air was escaping, and when I plugged the hole with my finger, after a couple of seconds no more air escape and suspension rose normally.but the problem reoccurs every time I re start the range, I'm going to...

hello all, happy new year. right, refrbished my pump and valve block six weeks or so ago. car has been fine since then, then yesterday i noticed it was slow to respond to height changes. i dropped it to access, for access, and now it wont rise. tested pump, sucking and blowing, all fine, height...

Hi all, i stripped and refurbed my valve block yesterday, and now as soon as I start the engine I get a hard fault. I clear it with a kicker, but it comes back seconds later. Does anyone have an idea what I might have done wrong? Thanks all.

Can someone please direct me 2 the eas relay position. sensible answers only please. Thanks

got home a few nights ago,locked the car as usual and i could still hear the compressor running. thought it would stop after a few mins, sso went indoors and forgot about it. came out in the morning to a completely flat battery,any ideas would be greatly appreciated.

Hi all. I wish to tap some of that vast sea of expert knowledge out there. This has happened only twice in the past three months. Suspension has gone into hard fault and when I reset I get " re valve stuck". Would that be a solenoid. ? Thanks in advance for any help.

Hi everyone. A little help please from a computer savvy person I purchased the lead and software package off eBay loaded said Software and USB to serial . It tells me to look to see which port has been assigned but having Followed the directions. No sign of any way to view Which port to...

94-98 and 98-02 When choosing spares these dates are a change point. My 4.6 hse is December '98 ! How do I tell which applies to me. Sorry if that's a dim question. Please be gentle with me.

Hi all, both my mirrors dip when selecting reverse, but when i select drive again the passenger side returns to normal, but the drivers side takes another trip down. any ideas ? I have the dip feature turned off at the moment,but i would like it back. Thanks in advance.......:behindsofa:

Hi all, can anyone tell me whats different about my `97 rangie ? it says on the log book "limited edition" Sensible replies please.........:)

FINALLY BIT THE BULLET AND DECIDED TO CHANGE MY FRONT NEARSIDE AIR BAG YESTERDAY (LUCKY I DIDN`T LEAVE IT TILL TODAY, IT`S POURING). ANYWAY, I FOUND IT EASY TO CHANGE THE AIR SPRING, ALLTHOUGH GETTING THE WHEEL ARCH VALENCE OFF PROVED A LITTLE TIRESOME. I`M ALMOST A MECHANIC. !!!!!!!:mooning:

hi peeps, could someone please tell me how to remove the radio unit, 1998 p38. ta everso.:confused:

hi all, any advise would be helpful,when i set the cruise it just keeps accelerating without end. !!

new owner looking for some introductory fun..