Search results

My TD4 has been running badly last few weeks, missing a bit at first, then losing power gradually over a journey until it struggles on hills - it eventually gives up. Just had a diagnostic check done by local indy and it shows 3 injectors have failed....is it realistic that 3 could fail like...

2003 TD4 Serengeti in silver. Great condition, owned for last 4.5 years with good service history. 10 months MOT. Many replacement parts, including: clutch bosch injection pump injectors brakes brake pipes New fuel pressure wiring loom EGR bypass New Toyo 785 all-terrain tyres, including...

2 kumho all terrains in 215/80/15 Virtually new - only done 30 miles...! £120 pair, pickup east Lothian/Edinburgh.

Genuine Simbars 3 cycle carrier for Freelander 1. Fits to spare wheel. Simple and effective. Comes with padlock and in good condition. £45, pickup from East Lothian area.

Can anyone point me in the direction of a decent supplier of recon injection pumps? My Bosch CP1 is leaking and need a new one. Preferably north of the border, but ok with down south if they post and accept return of old unit. ta.

My TD4 smokes quite heavily on first time start-up, but only when the ambient temperature is fairly mild. When it is freezing, frosty etc, it starts up with minimal smoke - any ideas, folks, what might be the root cause of smoke when it is milder?

I'm thinking of buying a 12V mini strip light to wire into the boot area - the standard light on the right hand side is feeble and a brighter light would be much handier in the winter. Would it be a simple matter of adding new wiring onto the existing interior light, or would it need a new...

Anyone got a set of 20 alloy wheel nuts that they'd be willing to sell/post to Scotland? ta.

Tried searching the forums but couldn't find any specific posts on this - I want to remove and clean the inlet manifold. Is this relatively straightforward and quick to remove? I've replaced the crankcase breather and have fitted an EGR bypass, just want to complete the picture. Thanks.

Anyone got a set of the 15" 6-spoke alloys in good nick, they want rid of? Tyres unimportant, just the rims would do - for an 03 tD4. ta.

I have a diesel leak which only occurs during winter (it happened last year too). I suspect possibly the seal on the high pressure pump, as this is a known symptom......trouble is, not sure exactly where it is located - can anyone point me in the right direction? many thanks.

Last year I had leaking diesel but it disappeared by spring/summer. Now I have the smell in the cabin again and the characteristic diesel on the underside of the undertray etc. I know the answer is to get the tray off and get underneath, not an option just yet - are there any types of leak...

Anyone fancy a cheap Synergy2 for £90 posted? Only been on Landy 5 months - one of the plastic lugs on the connector has broken so needs a plastic tie to hold on - otherwise excellent and hardly used.

I've just put up a used Synergy2 in classifieds in case anyone is interested.

En route north yesterday on the M90 the TD4 died very abruptly, engine management light came on and I luckily managed to drift into a layby. A complete non- starter, so the recovery guy plugged in the code reader and it initially came up with a generic catalytic converter/lambda fault. It was...

Strange problem started last summer, ceased abruptly in Oct last year and has now started doing it again. Symptoms occur with clockwork regularity - after sitting overnight, about 6 miles into a journey, the car will hesitate whilst cruising and each hesitation will be accompanied by the...

Can anyone recommend a good supplier for drums/shoes for a TD4 at a competitive price? Presume these are fairly easy to replace. thanks. B

TD4 is due an oil change, but recall that I overfilled it the last time due to the official spec oil capacity being too much. Can someone remind me what the proper capacity is? The search function isn't working for me hence the question.....cheers.

I've got the usual problem with water in the boot cubby, pretty sure it is condensation related (exhaust) rather than a seal leak. Has anyone tried to insulate the cubby from heat off the exhaust? I think perhaps a heat shield or perhaps some adhesive insulating material applied to the underside?

The time has come for clutch replacement - managed to get a year out of my 2003 TD4 since I bought it last January, but 1st & reverse are now getting quite tricky.....the master cylinder was replaced about 6 months ago as a 'may as well try it' quick replacement, however I need to get the clutch...