Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. O

    Series 1 bulkhead pillars

    Hi all Can you use series 2/3 bulkhead pillar repair sections on a series1 bulkhead. Particularly the bottom part below lower hinge Thanks Oily
  2. O

    VCU repair

    Some time ago I remember reading an article (Australian I think) That told of how to repair a VCU unit it listed oil type and quantities etc. But I cannot find it again. Has any body got a link to the page. I have access to a full engineering workshop so was going to have a go at fixing one. Oily
  3. O

    Tailgate Regulator settings

    Hi Should the tailgate regulator/ window runners sit hard against the guide top with the glass up or should the glass top out first allowing the motor to stall and the current cut out to activate. Only I have just taken our regulator out as it's jammed. On inspecting the cables there was no...
  4. O

    24 Volt to 12V

    Hi To convert a 24V engine to 12V besides Alternator, Starter, distributor, coil and plugs. Anything else required?. Oily
  5. O

    tailgate glass stuck

    hi all here is the problem. The rear tailgate glass will not wind down and the door unlock. Tried the re calibration trick, door will open but glass still will not move down, fitted new relay no luck. Still stuck up!. With a meter in the back of the motor plug get a momentary 12V then nothing...
  6. O

    steering box s3 into s1

    Hi Ive got a series 1 which has developed a crack in the steering box casing between the rivet holding in the column and the top of the box. Question is I have also been offered at a silly price a new s3 box, but it's over 200 miles away so I cannot compare them. My question is will it fit?. If...
  7. O

    wanted 86Inch Series1 chassis

    Wanted 86 Inch series 1 chassis anything considered as long as it's repairable. My existing chassis is past it, patch's on patchs etc. Thanks
  8. O

    Seat belts series 1 and 5 year olds

    Hi Anyone no what the law is regarding a 5 year old sitting in center front seat of a Series 1? It has no seat belts. Oily
  9. O

    Shuttle Valve switch long term failure what does it mean

    Hi all We had all 3 lights illuminated on the dash. Investigation by myself showed 1 A sticking throtle (throttle houseing changed for metal type) 2 Dislodged wheel sensor (changed) 3 Broken HD switch (resoldered) After doing all the above I had the ECU/lights reset by the local Land Rover...
  10. O

    ODB interface

    Okay I've got the cable and software/pc but I assume there must be somekind of interface required. It cannot be RS232 can? Oily
  11. O

    Head Gasket again or not?

    Okay I no it's been covered before but could not find the link. My question is We have a 2000 1.8 Freelander it had its engine replaced at 40,000 (in 2003) by Land rover agent with genuine Land rover engine. The thermostat was moved at the same time. It appears to be using about a cup full of...
Back
Top