Recent content by marti 300tdi

Hi all, Few weeks back the speedo, rev counter, temp gauge & basically everything on the pod packed in so I checked the fuses and yes one was blown so replaced it and it was fine for a few days and the pop it goes again, I have checked for chaffed wires or loose or disconnected earth wires but...

Thanks, I assume the wheels are 7" wide, you know type? I think I'll get these as the alloys are getting a bit scuffed.

This always is in the back of my mind when straining the landy up a steep hill off road, sometimes the sheer grip is amazing which must put a hell of a stain on the car. Good work. P.S. what is the tyre & wheel sizes in the picture; looks good.

Hi, Can anyone advise if any other Rover or other front seats will fit the 300 without massive mods, the current ones are shot and the spings have just given up on the drivers side. I have visited all my local breakers who for replacements but all sold or just as bad as mine, any help folks?

Hi, I have now got the Dickie seats fitted and what a difference now, I also have fitter the grab handle but am stuck on finding suitable existing holes for fixing the back door interior handle, has anyone retro fitted this before that can remember how this if fixed, thank in advance.

Thanks discool, are these retro fit units expensive and can they be fitted by a non tech like my?

Hi all, my 95 (N) disco 300tdi does not have the blip thingy, never had one when I got it and it's a pain checking each door is locked when parking up. I was thinking of taking one of the door panels off to see if there is any solenoids fitted and to see if they work or do some of these models...

I strongly recommend Keith Elgin Motor Engineers of Edinburgh who do all my work on my folks TD5, Keith is very very clued up with Land Rovers and all of their quirks and charges far less than the dealers without compromising quality of work, they are in Canaan Street Lane, Morningside Edinburgh.

Theres a guy on here telling about gas and other useful stuff but I am sure he could trawl through this forum and find something similar, I also see other items which can be put on another title; with respect.. get a grip mate.

If know one posts an answer in here for others to read and to assist others like the title says what is the point of it, sorry but way to strict here for me.

????? What do you mean?

Hi, After much messing around with all sorts of new bearings, new tensioner, THE PENNY TRICK, stripped thread in block, new dayco belt, change of power steering pump pulley & pump, genuine lan rover belt and it was still bloody squeeking.... I tell you this really drives me mad, well I have...

We sure have had plenty of salt on our roads up here but strange thing is the nearside is perfect. I would have said the corrosion was down to a previous owners poor body repair but he has had it from new and hasn't even put a scratch on it, I don't fancy getting the welder out to such a nice...

My friend poped over today with his 51 plate Discovery Breamar and on close inspection I noticed that the bottom of the rear quarter panel is flapping about at the bottom. The lower section of the inner wheel arch liner is rotten! I my mind this is still a relitivly newish car, surface rust to...

Well, I went to fit the tensioner today and found that the 15mm retaining bolt to be stripped and the aluminium threads came out with the bolt :mad: After some minor drilling and installing a helicoil & a dab of loc-tight all is fitted including a new belt, quite easy and accessible job I must...