Recent content by caepabi

You was right sierrafery, the fuel cut of needed resetting, it now starts, but not smoothly, I just need to get everything set up. cheers again

Cheers Sierrafery, I'll give it a go as soon as the rain stops, (which could be in quite a while here in Wales

I've just done the heads on my V8 and I think I've connected everything as should be, when I put the battery back on the car the hazards flashed and the car wouldn't turn over. I used the EKA code and now the car will turn over but still wont start and the hazards still flash. Is the...

Has anyone got a full or part of a fuel pipe from the petrol tank, I need the fitting that goes into the fuel pump unit, preferably with a small amount of pipe attached so I can connect it to the existing fuel line. Also are they the same as on the diesel motors

It all depends how bad and where it's rusted, if it's a little bit on the rails then plate it if its the rear cross member that shot replace it.

Cheers Landowner I've already done all the brakes so I have a flaring kit already, all I need is some pipe and new P clips and I'm away.

It's now Sunday morning and I have no LPG tanks and no petrol tank in the car, it also has no road tax or MOT. I need to do some work on the chassis, that's the reason for removing the fuel system. I live in a small town in mid Wales and professionals of any kind are hard to find. Once the...

I have a D2 with twin LPG tanks in place of the petrol tank, at the moment the tanks are hard plumbed all the way up to the engine bay. My question is, does it have to be hard plumbed or could it be done in the rubber pipe used in the engine bay. The reason I ask is, I have to remove the...

I now have an office job (not allowed in the workshop anymore ) so keep my engineers eye and skill going I bought a Landy

For some reason it failed to upload the pictures but if anyone wants some drop me a line. anyway it's taxed and tested until December. It's not a Rolls Royce but it should keep going for a good few years yet. It has no headlining and I ran over the steering column cover so that'.s missing as...

I have a 1989 crew cab for sale. I've done loads of work on it but I now need a disco, (getting old) from the rear, new lights, new strengthened rear cross member, shocks, poly bush kit, fuel tank sender, alloy cover on gas springs covers the back with an stainless steel rack attached, a...

You can learn a lot on these sites

Thanks for the info Rich, I've not used Bearmach for parts before but there catalogue seems to be very good. It also helps knowing the chassis number the engine came from. One day I my find out where all the parts come from. Cheers

I have a land rover defender with a discovery front axel, the hub is knackered and needs replacing. Because we don't know the age of the axel (only that it came from a 200) I have been told (by the garage repairing it)there are 4 hubs it could be and until we find the age of the doner vehicle...

Thanks for the prompt reply, it's saved me a 2 hour round trip to the nearest dealer