Recent content by AT31916

Help Ive got a 2001 freelander 1 TD4 that wont start it will just turn over Any suggestions Thanks:confused::confused::confused:

Help I got a three door 51 plate TD4 and it's gained itself a knock at the front end not unlike a drop link knock but it's not the drop link!! I've also changed the shocker thinking it was that including the yellow bump stop, but the knock is still there 😡😡😡 Anyone got...

All Got a slight problem with my 2001 TD5 defender, It develops a vibration and slight loss of power and a very very slight misfire, this fault only comes on after half a mile start from cold then gets worse as it gets hotter Any suggestions?

Is the new style rear door lock with the provision for central locking the key barrel bigger that the previous one without central locking?

All Has anyone managed to successfully fit central locking to a pre 2002 defender 90 van I have fitted successfully the front servos but struggling to fit the rear as the lock mechanism is burst proof and I cannot get into it Can anyone help with a solution Thanks in advance

All does anyone know who's the best at remapping the TDV6 engine looking for both power and economy Any suggestions Thanks

All Does anyone know if its possible to switch on the 4x4 info on the satnav on disçovery 3 SE mine is a 2008 08 plate Thanks

All I plan to fit a DID headlamp kit to my 2001 TD5 defender, therefore I need to disable the dim dip function on the headlamp as it would mess up the HID kit. Does anyone know what to do to disable this function:confused: Thanks

Help My 2001 90 TD5 won't start it turns over but the fuel gauge goes to empty and the pump isn't working Also I can't purge it could it be the yellow relay under the drivers seat? It has had the injector loom changed 12 months ago

Yes agree I changed the bumper loom about 4 months ago had in bits an is ok

All I have a 2003 disco and it's parking sensors have decided to be on continuous when in reverse with no fault flashing on the dash switch any ideas anyone?

All New nuts for the cover plate genuine parts fouled on the cover plate causing it to stick and not work Arrrr

We had a struggle getting the last bit New arm was due to the old push rod wearing away it's self and the socket it sits in all genuine parts apart from the clutch kit it is britpart

Yes brand new genuine release arm

Just taken box out and clutch is fitted correctly, We endoscoped it last night and the release bearing was pushing the fingers about 15-20mm is that the correct amount to clear? Anyone got any suggestions for next action? Thanks