thanks again when putin the lifters back in do you squash the oil out off then thanks david

thank for that goto give it a go if it works i will post back on here thanks david i have done about 15 rover head gasket and this is the first only i have timed up after taking the head off

been told by rover that you can seal them back in with some blue sealer they say when the head is back on they should not move and they wil seal david

after taking thr head off my freelander the wet liners have moved when i turn the crank to time it up what should i do please help thanks david

yes i am sorry cant help you then :) david

mine been wet too my problem was water was getting in by the rear light thanks david there sould be a rubber seal behind the light :)

hi there ssl where are you from may be able to help you thanks david :)

thanks i will have to have a look:)

ok then but it ony makes the noisy when the clutch is up when you press the clutch it gose a way when you have the clutch up the thrust bearing is not going round only gose round when the clutch is pressed :confused: :confused: :confused:

hi could any one helpme just got a freelander 1.8 petrol s reg there is a noise from the gearbox i think when sitting still with the engine running there is a noise but when you put the clutch down it gose a way is it the trust bearing or the gearbox thanks david :confused: