What have you done to your Landie today.

made a panel to replace the rear window in my s3 hopefully it will stop some of the rain blowing down my neck but i doubt she will ever be wind and water tight

Sorned it..again

will it ever be finished:doh:

finally go around to fitting a thermal fan to replace the viscous fan on my 200tdi conversion,I found a large fan on a fiat scudo van in a local breakers and managed to fit it inside the original disco rad fan housing and I think it looks quite tidy so just got to fit temp switch and its all done.

**** all, weathers ****e

Managed to remove the steering box out of the Range Rover, what a lump of metal that is. Order new one tomorrow.

Put some diesel in her, wow it hurts everytime!

Fitted an all singing all dancing alarm to go with the existing imobiliser. Not that it will do any good if the local pikey's spot it.

Been lying underneath it in the mud and rain with a dodgy torch trying to find a problem that didnt want to be found

Fitted two new rear bump stops and fixed the rear fog light ready for the mot next month!!

Bought some bolts and exhaust paint today

Also all new pipes arrived

Fitted new front brake pads and took it along to the MOT... came back an hour later to be presented with a fail list as long as my arm.

Need to do both track rod ends, both tie rod ends, seatbelts, rear fog lamp etc etc etc

Cried when I filled it up!

Fitted new tubular bumper and rock sliders.

BearDy89 said:

Fitted new tubular bumper and rock sliders.

Click to expand...

i'm looking to make one like this ,do you know what the o/d of the tube used is bear?

Changed the Clutch Master and Slave Cylinders, mobile again!

Also spotted the where the front prop joins the axle only 2 out of the 4 bolts are fitted

just fitted new fuel tank 2 my 90 old 1 started 2 leak tuesday morning wot a dirty job that is lol

fitted my bumper end cap and started weldin the little hole in the chassis...

turned into a big hole in the chassis... 3 hours later... 90% done and ran out of wire!!!

no where open... nothin to do but put everythin away and start again tomorrow... after i got some more wire...

oh and put some new rear arb link bushes in... not much left of old ones...

gotta try everythin..... mot friday!!!!

bigsi13 said:

i'm looking to make one like this ,do you know what the o/d of the tube used is bear?

Click to expand...

three different sizes i will measure tonight and let you no.

the main cross bar is obviously the largest, then the Abar is smaller and the two angled supports smaller again.

getting an alarm fitted

drove the 110 back from bristle airport glad ta be home and driving me landie again , dont want ta see a fookin coach for a while and any luck wont have to ride in 1 for at least another 12 month