mogger7
New Member
- Posts
- 23
Guys I've got a 1966 series 2a that I picked up as a basket case basicly' Prior owner bought a new clutch then lost interest. Took it apart and found out the clutch he bought was a 9 1/2 and needed a 9 inch so I bought one and started going through all the bags of nuts abd bolts from prior owner taking this apart. In removing the old clutch I noticed it was darn near new .????? So I put the new one I bought into the rover and in hooking up the clutch linkage notices the lever on the bell housing is not horizontal as most pic's I've seen so my slave cyl. will not extend far enough to release the clutch . Can any one tell me if this scaft could have been pulled out and reinstalled in the wrong location ? There is a fine spline on this shaft as seen in the manual and thought it may have been installed wrong. Don't know why any one would remove this but??????. This is the most off the wall chutch release set up I have ever seen . Those of you that have been into this early type know what i'm talking about. those of you who have the later type throw out bearing (your lucky) Any help would be great
thanks
mogger7
thanks
mogger7