thizzlemania91
Active Member
- Posts
- 241
How do i get this off i cant fin the black part to it. I searched everywhere and cant figure it out :/ my three amigos are on HDC, TC and ABS lights are on.
Brake wire harness removal
- Thread starter thizzlemania91
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
ZDomZ
New Member
- Posts
- 1,723
- Location
- South Norfolk
Ehh?
Not making much sense. More info needed please. And the typo doesn't help?
Not making much sense. More info needed please. And the typo doesn't help?
thizzlemania91
Active Member
- Posts
- 241
Im trying to change the brake wire harness. I ordered a brake switch along with the brake wire harness. I removed the brake switched already but im having a difficult time removing the wire harness. Hope it helps.
ZDomZ
New Member
- Posts
- 1,723
- Location
- South Norfolk
Ahh... I think you mean the bit by the pedal....
Look at the three amigo thread and (as I read it -as I haven't actually had to do it) the harness is an adapter that plugs into your existing loom. It isn't a replacement section.
http://www.landyzone.co.uk/lz/f9/3-amigo-brake-light-switch-replacement-guide-125617.html
Look at the three amigo thread and (as I read it -as I haven't actually had to do it) the harness is an adapter that plugs into your existing loom. It isn't a replacement section.
http://www.landyzone.co.uk/lz/f9/3-amigo-brake-light-switch-replacement-guide-125617.html
thizzlemania91
Active Member
- Posts
- 241
Awesome thanks man 
i though it was a replacemet wire haha you rock bud
i though it was a replacemet wire haha you rock bud thizzlemania91
Active Member
- Posts
- 241
Three amigos still on dam. Is the plunger supposed to be springy? Where is this ABS sensor??
Hippo
Lord Hippo
- Posts
- 52,116
There's 4 abs sensors. You can measure them manually to check their resistance. Also use a meter while spinning the wheel manually to see if they pick up a signal. 1 for each wheel. Look for yellow connectors on the inner wings under the bonnet. 1 is next to the battery. The rear connectors can be found by looking up at the rear wheel suspension area. Alternative is a diagnostic to see what the error codes are.
thizzlemania91
Active Member
- Posts
- 241
LandySurf
Active Member
- Posts
- 164
- Location
- London / Cornwall
Really good thread! Useful advice - thanks
