Kawasaki green?!?! On an Oxford blue Disco? Ignore that noise, it's the style police breaking your door down hahaha White is a possibility long term once the vehicle is mine but for now things need to be low-key so it's black or pewter pretty much

Heeeeeey, assuming you are referring the the 5 spoke deep dish alloys...I'm kinda partial to mine and looking forward to fitting them with a set of Insa Turbo Tractions ;) Considering doing the paint on them in black though as they need a repaint...undecided :)

Fix it! We payed £1495 for ours recently, just shelled out £1229 at the local specialists and probably £150 in misc parts some of which are waiting to go on (I'm not including the expansion of my toolkit in that haha) But like my In-Law says, she was ready to pay £6k for whatever new vehicle she...

There are ISO adapters for plugging in the original sub... I simply replaced the mini amp and it's speakers with some sub speakers of the same size that don't require amplification then wired them into the hinge-side rear speaker. Works fine for me for everything I listen to but then I don't...

Personally what really puts me off of the TD5 is the horror stories of the block cracking, not read anything comparable about the 300 (and not read much in general about the 200) :)

The other thing is it won't open if the external release lever isn't fully extended, push it towards the vehicle before pulling it back to open it.

So you (potentially) want to put a less reliable engine into an older vehicle for reasons of a possible power increase on a non "performance" vehicle? to quote a meme "Dafuq did I jus' read?" ;)

Inside the vehicle also makes it viable for "sneaky swaps" for anything that is likely to read or photograph the front plate ;)

Ok folks, not got a lot of knowledge when it comes specifically to car paints, Industrial Solvent Oil Based Paint LAND AND RANGE ROVER 602 OXFORD BLUE: Amazon.co.uk: Car & Motorbike can I paint that onto my landy via the roller method? Or does someone have a better recommendation for paint? I am...

That was one thought but may actually do both just to create more storage space to be honest. (Need to leave one dickie seat in as got 3 big dogs and may need to sit in the back on emergency vet trips) Was going to use that idea as a practice in metalworking (cutting and welding) and literally...

Gunna have a good look when I pull the console out as I am looking for a good spot to put in a basic toolbox but ideally want it out of public view and without ruining our good interior so possibly under the big storage pod.

Yes, I do need to do that again (improved them with a quick clean but want to do them properly) cheers for the reminder!

Ok, following on from another thread I will be fitting a reversing camera to always be on, will be fitting this to the 12v lighter line and doing it properly (so removing center console etc) What I want y'all to do is give me a list of jobs to do that require the center console out to do so...

Mine has one of those things fitted and it wasn't even mentioned on it's recent MOT (a failure for other reasons but tow bar not mentioned lol) and by recent I mean last Tuesday.

I'm no expert by any means but would it not make more sense to seal them than to try and paint the inside of them? Otherwise the only thing I can really think of is getting them dipped professionally.

Ah sorry, typed that before refreshing so didn't see Brian's posts :)

Just to re-iterate a question made here, is that plate riveted on? to remove it to make repainting a bumper easier to I just remove the grey studs? (would like to re-use it)

Cheers but I'll be following Dr Evil's advice and getting something more functional.

looking at them could they be impact sensors for some form of safety device?

Cheers for the advice mate