ive ordered a set of GT Radial All terrains instead, they were on special offer!

Check the rear A frame ball joint on top of the axle, this will cause a clunk when taking up drive, stick a crowbar onto it and give it a wiggle, bear in mind its not supposed to move too much

i would just get underneath it with a decent torch and inspect every aspect of the suspension and steering, give everything a good going over and try moving ball joints and check suspension mounts with a crowbar to just see how much movement you are getting. Thinking about it, if you jack the...

Hi Guys Has anyone used the Insa Turbo Traction Track Offroad and On Road? as my 90 is mainly a road car with some greenlanes/playdays on the occasion, and i wanted to know if anyone uses these and if they are any good?

christ i hope not!

hi im trying to identify what a sticker means, in the engine bay, its on the bulkhead by the brake master, a small black square sticker with a 1.56 in it? does anyone know what it is?

i had the same problem, mine was warped by 4mm along the face, a quick skill in a mill later and quite a few problems have vanished!

I think if a seller diddnt let you poke it with a screw driver you should be worried to be honest, ive let people poke the chassis before just to prove how good it is! well as a benchmark i recently bought a 99 90 TD5 softtop for £6500 although tbh now with a few problems surfacing i belive i...

Thank you very much james, saved me a load of hassle!

ive adjusted the arm and now its perfect, it diddnt help my manifold was warped by 4mm! though, thanks for all the help

round are normally the engine ones, but if they are the same thickness then they should theoretically work on either

its not fun at all, infact its an absolute arse of a job! and this time im doing it alone....

Mass Air Flow Sensor, it sits in the air intake system and measures the flow of air going into the engine

well there are two mounts either side of the engine, but the gearbox doesnt actually have any, the rear mounts are on the transfer box and if i can recall properly are basically a square of rubber with a bolt sticking out either side, how much smaller are they? as the ones i had on mine were...

normally just depends where about the hole is, ive gotten away with a few in unimportant areas, but good luck anyway!

what engine is in your landy?

After much head scratching and beer drinking i have come to realise that i may have put the clutch friction plate on the wrong way, as it wasnt marked i took a guess and have gotten it wrong, so its another engine out and a swap round. i hope other people find this useful,

Hi guys, I have got a misfire at high revs on my 90, and im chasing the problem all over the place, ive landed at overboosting because after i ran the engine with the turbo actuator off it stopped the misfire making me belive it doesnt work. So ive had it tested and apparently the actuator...

its mainly when moving but slightly on static, could a warped exhaust manifold cause it?

Just getting a lot of loud vibration in the higher revs, i think its an injector misfiring at high rpm, it idles beauitifully but at around 2500 it vibrates like a bag of spanners, ive changed the dual mass flywheel, and the crankshaft pulley damper, and its the same in high range and low, so...