Right folks. Well first of all I would just like to say a big thank you for your help - proving once again LandyZone is a corking forum full of very productive and helpful individuals.;) Following your advice Ming I disconnected everything on that circuit and then re-connected one by one. It...

Aw I will get round to it sometime this weekend.....at the moment there's beer to be drunk.;)

Mark the flanges the the rear diff and IRD so you get it back in the same place. Undo the 6 bolts at the front, 6 at the back, belly under the VC and undo the 4 support bearing bolts. Its quite heavy but nothing too bad. Best to breathe in as you undo the bolts and breathe out to lower it down...

2 tyres on the kerb....2 off...Beer gut to take the weight of the VC ;)

Prop shaft bearings? Try dropping the prop and taking a test drive.

Cheers Ming....will go gremlin hunting tonight armed with your good advice. :D

Cheers for your help on this Ming. No trailer socket.:( Where do we go from here? Hang on - the lights on the heater buttons have packed in too...would this be related?

Thanks Zippy. Disconnected all the adjusters and the connectors for the lighs front and rear..same thing - blows as soon as sidelights switched on. Slowly running out of fuses LOL.

Tiny has the Halfords "rally" main bulbs and they make a huge difference on full beam...like having some extra spots fitted. Normal driving gives off a nice crisp white light.

Rear diff - low miliage - make me an offer....:D Keep tripping over the bloomin thing every time i go in the garage.

My hero Ming! :) Its fuse number F28 Headlight adjusters and heater panel lights also out. I have a multimeter but am gonna need some serious basic instructions if you need me to use it. God I am hopeless with electrics!!:(

Hi all. Tiny is in need of your help as her owner does not have a clue when it comes to electrics! :confused: Dead easy (for some) - fuse blown on N/S headlamp. 10amp. No N/S sidelights front of rear. Replaced fuse - blown again. Checked bulbs - all ok. Disconnected wiring to front and rear...

Is Tiny winning then? :D

Nah, this replaces the airbag, or rather the airbag replaced these...:D

Go on, put me down for one.;)

Always worthwile investing in some quality sound deadening and anti drumming pads while the door panel is off too.;)

I am not talking about folding the mouse mat in half and jamming it under the bonnet slam panel.;) The wings, grille, arch liners and wheel arches are all placcy (and not very well fitting on the early models) so taking up the rattly slack merely stops them resonating and no fear of rust unless...

Right fella - I think I may have sorted the buzzing humming noise that comes in the low revs and goes as you rev through it. For this job you will need. 1 - An old mouse mat 2 - scissors 3 - tent peg Step 1 - peel off the cloth mouse mat cover and discard. Step 2 - With the scissors, cut the...

Most probably. Common L series "feature" apparently. Once the belly pan is off its easy enough to do once you have one of my "special tools" ;)

Taipan - just had a thought - would you say the noise is comming from the fuel pump belt area? Changed it recently / at all?:confused: