Welcome back Andy. You haven't missed much JohnM70 came out as Trans and now working the streets of Portsmouth. Nig identifies as a Black Lesbian Onlyfan pornstar as Trixie Landyzone.

I know this is an old thread, but if someone is here because they are having a similar issue, then it might be due to the thickness of the circlips. I recently purchased new GKN UJ bearings for my 1977 S3 and, upon opening the boxes, noticed...

any images of the battery connections main earth cable and the starter motor and alternator connections .have you checked the output voltage on the alternator main connection and then on the starter motor main connection and then the battery

Using a multimeter to check battery voltage with ignition off, then on, then running would be a good start Nice place Torridon called in there doing the NC500

This was it , and I posted about it, thought I bought it with the sides but I must have cut and welded reading this back https://www.landyzone.co.uk/land-rover/rear-door-bottom-repair.338756/

Been a mammoth project for you but you can see the finish line, I did my rear door with a new bottom repair piece which came up the sides and a new skin but it seems to dent easily can’t have been the proper birmabright spec.

Thanks!, I still have door tops to build up for the front, fit the 2nd row doors and build up, a front wing to be painted, rear safari door to repair and paint, and not forgetting to complete the wiring, fuel system, sort out seating, etc… so...

Lookin very nice indeed, can’t me much more to do?

Hi Folks, here’s one of my infrequent updates 😂. Got a few bits done but was interrupted by holidays, work and Ill health, but here they are… I cleaned, painted and refitted the vertical angles as per Wagon Loons side windows. Makes sense now...

Ouch, Sod’s Law! makes me recall when I was a mechanical apprentice many years ago had a spell in the foundry when they cast large steel stem turbine casings the header tank made of resinous sand gave way with white hot metal falling from a...

That’s me… Safety third.

These were my readings and a local company on my 2286 diesel , the wear was not bad but I went for a rebore anyway 2 years ago with pistons off eBay The rebore was £249;+vat and pistons just under £100 Have you checked the piston ring end gaps

Cutting kitchen tiles once with the grinder and wrap around sunglasses. A tiny shard of tile bounced about and stuck in me eyeball. Went to hospital and they numbed me eye, then scratched around with a needle for a bit until they got it. Eye...

Front or back axle ? To confirm, you want length between outer edge of both flanges And the radius from main tube centre to the outer flange And to what degree of accuracy is acceptable

Hands up - I hardly ever reach for them when cutting/grinding (not that I do that much). I will now - so thanks for the reality check 👍