thats utter garbage anyways, you wouldnt get high CO and normal HC with failed cats high CO = its running rich, normal HC no/nominal unburnt fuel, ie no misfire or bad valves diag will tell you if an o2 sensor is running ok, fuel trims will tell...

and rattle :D

Plus the cats can fail after time and or crack inside letting gas through without being converted ☝️

If the cats were out the post cat lambdas would show a deficiency 🤔

You see, cake makes it all better... Damn... That's what I'm missing😱

Had a cup of coffee and a chocolate brownie whilst I prepped the new side steps to go on the rangey. Then pressure tested the AC system, found a hole in the condenser, drank more coffee and ate the other 11 brownies in a fit of depression, then...

It could be the handbrake. A lot of cars do it. As the sus drops the angle of the arm changes at the rear and can force the handbrake a little. Your on cable and not electric aren't you @gold rover? 🤔

I've gone off mars bars. I'm on a Double Decker fad at the moment.

I like your hat😜

And your trusty 38' in the background 👌

À collector hey🤔.. 🫣

Oh happy days :D :D 👍

Lemforder or meyle, sometimes meyle do HD versions of some parts. Febi are now buying everyone else's stuff and boxing it up like, continental do😩

I got another toy!! I mean.. p38

Dont forget the dished washers on the pump mounts go a certain way they should dish )( that way not (). and whey only need to be nipped up not screwed down tight

A big no to moog parts, utter crap lad 😞

I put a moog joint on the other week with the much appreciated help from @Flossie and I'm pretty sure it's rattling again already

Have already ordered full set of Delphi's . But thanks for the offer 👍

New MF31-1000 battery ordered for delivery tomorrow hopefully even though the old one is still showing 12.7v from last night.

A phone call to a guy with all the right tools whose done the job before numerous times and he can fit me in Friday so not turning him down

blimey! appreciate its less work.. but trying to get mine booked in was going to be a month

had an argument with a pot hole the other day and had problems with driver side front. Juddering and pulling to the right when driving. Got it up to the yard this morning for it to be looked at and damaged bottom ball joint was found to be the...

Make sure you can get the filler open before you undo the drain. A normal 1/2 inch square socket fits perfectly.

Thank you very much! these seem to be nuances - I have now refilled maybe 50-150 ml and it is perfect! Super! Now comes the differential oil.

You'll loose some in the new filter. If your piston rings are all good then it might take a while to run down into the sump. Always fill, run for a few minutes and then top off.

Did you fill the new filter before spinning it on? I doubt it makes loads of difference, but it might make a bit.

Shouldn’t need time. Mine drains down to the sump pretty quickly. Do you know where the oil was before you started? At the end of the day, you need to fill the oil until it’s at the top mark on the dipstick. On mine, the difference between the...