no sorry my mistake, it bubbles only with the compressor running . Doesn't bubble with it off.

When I took the diaphragm end off the disk style seal had torn and nearly all the o rings were flat. The only issue I have now is when I leave the car and pull the relay out it airs down over the course of a few hours/overnight , so I do believe there is an air bag leak. Sprayed soapy water...

Hi mate I'd just like to thank you, I've rebuilt the valve block and after some fiddling around with a split compressor pipe it air up extremely quick . Cheers 👍👍

Dealer can be three times if not more than say all makes 4x4 , the dealer part isn't going to last three times as long

Like most specialists and dealers

They were supposed to be a reputable land rover specialist , I took my discovery 3 there a few times. They said the P38 is a specialty of it's own and neither of them had any experience of them. Threw a big spanner in the works as I would like to preserve this car which is quite hard with...

There's enough guides and YouTube videos I should be fine, and t I be honest this forum has helped me more than anything. Better than my local landy specialist who refused to work on my car , due to " no experience with p38s"

Ah , that makes sense , hopefully I can get this running. I don't want to have to switch to coils.

Il do it one at a time ,take pictures, and following the guide. What can happen if you muddle them up?

Right , rebuild kit is on the way . Seems reasonable to understand, makes sense if it's leaks as it took ages to change heights when it was working

no white powder thankfully.

I can feel air out of that also , put my finger on it and you can hear the air noise change. Thanks mate god send 👍 What's the best step from here ? Is it a rebuild of the valve block?

After I installed I ran the car for 10 mins with the door open and still didn't rise , I took that off and I could feel air put my finger on the port it made a bit of suction.

Just to be sure you mean this right ?

I have just replaced the compressor in my P38 after it recently dropped to the bump stops , it still will not rise and the new compressor is very hot. It's not a hard fault as I have no lights on the dash and the eas switch doesn't have all 4 lights on Any suggestions will be helpful. P.s I...