Bolts can be from Britpart (Island-4x4 or similar). Bushes I went original from Rimmer Bros.

Sounds like it. Where's the car? Greece?

Can you not just replace the rubber parts by cutting the pipes and use some compression fittings? Or has the cooler itself failed?

+1. Just grind the old bolt off and bang it out. New ones in.

MrGorsky's did that. Must have been a pinhole in the pipe to the spring.

She's been drinking that super unleaded again 🤭

Heaters won't matter. The pipes to the matrix are permanently open with the air mix changed in the cabin as required.

I filled and then sat squinting under the bonnet at the expansion tank. Hood the revs at 1800 rpm unless it starts splashing and jump out every so often to top it up

It is back in your garage is it? Thought it was in mine. Good job I didn't offer it then.

Update time. No new components were fitted when they tried the original repair, they broke it so wanted to fix it with minimal cost to themselves. Regarding the extra cables........ I have checked, it does actually seem that all P38s (certainly...

Had a little look on Amazon. Seems most of the cheap ones only have 5 trumpets and miss off the last note? Some compressors have 6 outlets which makes me think you could Tee it into the biggest one and sort of get away with it Vixen from the...

I shall dig through the shed and awaken the neighbourhood :)

Small update: polarity doesn't seem to matter on the new horns. They're not that loud though.

It'll be fine with the bonnet up.

Cannot see your location. Anywhere near Bucks?

If can possibly have a bar made like the guy in the video did that holds the two bolts and allows you crack the center bolt off it can be used in reverse to tighten it. 🤔

Oil burner is different. Until it gets very old. The v8 likes to leak.

Now you're going to have to post a video of them working!

It would make the idiots walking along on there phone jump a bit :vb-biggrin:

Go for it ... then I can borrow it.

teng tools are reasonable, arent they? just seen this.. tempted... https://www.ebay.co.uk/itm/334904186260 www.ebay.co.uk/itm/334904186260

Today i stripped the front end near side ,in preparation for new ball joints ,after 25 years not one bolt had a decent head on it but got it in the end just needed a bigger hammer :rolleyes:....

And indeed mine. Not surprising as I copied yours.

https://simplybearings.co.uk/shop/Seals-O-Ring-Seals-NITRILE-O-Rings/c19_4501_4705/index.html?page=11&selection=Nitrile+Rubber+Square-Rings It seems they do the square section ones, perhaps they can help you if you email them. Or these guys...

I had a lot of "fun" trying to get o rings for my Mustang injectors. Went to a specialist who told me that the measurements that are critical are the diameter and the cross section (how thick the rubber is). So you want to measure your Outer...

Could be fun with a pair each side!

yep, as in the General E Lee :)

I've found Wych Bearings to be very helpful in finding o-rings if you give them the measurements and use. Brake fluid is a harsh fluid though. Possibly ring Wabco in Buckingham, UK, although you will need the measurements as they threw all their...

Unfortunately not. Hopefully Denmark are sending some Viking longships to repel Trumpfart 👍🤣 I'm starting to regret not putting my name forward for work in France recently 🤔🙄🤣

I'm still none the wiser as to how much I'm going to pay for my car tax. The only thing I am sure of is that whichever government is in power they just screw the working man.