-Defender110- · May 30, 2013

So for a good while now ive had noise from around the drivers wheel,

noise is a jingling/rattling noise, similar in sound to that of two loose washers rattling on a bolt.

its not affected by engine speed/road speed/engaging or disengaging to clutch and seems intermittent. mostly it is only noticeable when the road surface is rough. ive been underneath and nothing is jumping out at me, have checked shock mounting bolts/washers, all steering connections, and pretty much all visible nuts and bolts.

Im intent on finding it though... for fear it falls off!! :jaw:

any suggestions of where to look?!

Station House · May 30, 2013

Um

Strange not affected by engine or road speed

See if the exhaust down pipe is catching on anything - had that on a Dolomite 1850 many many years ago and was similar to how your describe

Andy Land · May 30, 2013

Friend of mine has something similar and he's found out it's a spring on his X-brake. If you do happen to have one of these it may be worth a look!

ferretboy · May 30, 2013

Lower shock absorber rubbers squashed up and washers jangling around!!
Jack up grab shock and shake it !! New rubbers will be required !!

ratty · May 31, 2013

My money is on brake disc dust shields having come adrift.

Culminator · May 31, 2013

If its a tdi engine, check the exhaust manifold heat shield. They crack and make a tinny rattling sound.

MrJC · May 31, 2013

Had it been Christmas the jingling would have been easily explained

As would some small stones in a hub cap....if you are sure its the drivers side wheel area take the wheel off and tap everything with a hammer.... a real outsider would be is stones inside the tyre being kicked up and hitting the wheel.... I will have 10p each way on the dust shields.

Birdbrain · May 31, 2013

ferretboy said:
Lower shock absorber rubbers squashed up and washers jangling around!!
Jack up grab shock and shake it !! New rubbers will be required !!

Good call. Happened to me recently. Offside rear rubbers dropped off as large domed washer corroded away. Nut still on shaft but whole shock rattling in its mount.

Other causes:

Prop shaft UJ's
Exhaust.
Turbo heat shield.
Handbrake mechanism - when it rattles just try pulling the handbrake up a notch and see if it stops.

OxonLandy · May 31, 2013

did u run over one of santa's reindeers?

-Defender110- · May 31, 2013

Shocks and springs are all new but ill check again to make sure they are all tight, Ujs are all new too so doubt it's that, ill check dust covers, handbrake and heat shields this evening and see how it looks, thanks lads!

-Defender110- · Jun 1, 2013

FOUND IT!!! it was one of the long bolts that holds the front bumper to the chassis legs, it as a little bit loose and had a washer on the end of it, nipped it up, all fixed

MrJC · Jun 1, 2013

Well it was close to the wheel

and Santa is okay so happy days

ratty · Jun 1, 2013

MrJC said:
Well it was close to the wheel and Santa is okay so happy days

My landy doesn't seem to drive very well when I bolt my winch bumper to my wheel???

-Defender110-

Well-Known Member

Station House

Well-Known Member

Andy Land

Well-Known Member

ferretboy

Active Member

ratty

I'm not special I'm limited edition

Culminator

New Member

MrJC

Well-Known Member

Birdbrain

Well-Known Member

OxonLandy

Active Member

-Defender110-

Well-Known Member

-Defender110-

Well-Known Member

MrJC

Well-Known Member

ratty

I'm not special I'm limited edition

Similar threads