bigrichsri
Active Member
See post #11
See post #11
bigrichsri
Active Member
GRATCH
HUGE MEMBER
Yes. ok to hold a steel spare on the carrier.
Yes he's the twart who gives wrong advice to people like you.
bigrichsri
Active Member
GRATCH
HUGE MEMBER
bigrichsri
Active Member
bigrichsri
Active Member
Look at this scenario:-
forum member;- is it ok to fill my 300tdi up with diesel?
GRATCH;- yeah course it is I dun it loads of times, but you can't start the engine and drive it!.
GRATCH
HUGE MEMBER
GRATCH
HUGE MEMBER
Why is it unsafe to fill with diesel? you need to work on your contextual scenario's:doh:
bigrichsri
Active Member
Reduced speed??? No, you've lost me there.
bigrichsri
Active Member
diesel's flammable!
GRATCH
HUGE MEMBER
The prosecution rests it's case m'lud.
GRATCH
HUGE MEMBER
Throw a match in yer diesel tank then.
bigrichsri
Active Member
Lets agree to disagree. I think the nuts with the taper and the shoulder are ok, you don't. The garage obviously think they're ok too as it wasn't mentioned at the MOT.
bigrichsri
Active Member
GRATCH
HUGE MEMBER
So what happens inside an engine cylinder? Anyway thort you said diesel was flammeable? Make yer mind up
bigrichsri
Active Member
So what happens inside an engine cylinder? Anyway thort you said diesel was flammeable? Make yer mind up
It's a diesel vapour/air mixture inside the cylinder under extreme pressure.
oldskool
Well-Known Member
What ****wit told you that hold him by the throat and hit him with your 1000nm air gun, cock.
Are you one of these idiots who give out info to peeps on how to fix there landy (or any other vehicle) when you dont actually know what your talking about
.
oldskool
Well-Known Member
Your supposed to be an engineer so you tighten wheel nuts that should be done up to 130nm to (your words not mine) as tight as my 1000nm air gun would do them and then tightened them some more with a bar, yer right course you did.
Have you any idea how tight 1000nm or even 500nm as you now THINK your gun is actualy putting out actually is, i very much doubt you do.
And while were on the subject of air guns what make and model is yours and how old is it?
Are you sure your not mixing up undoing torque with doing up torque cos all the guns i have the doing up torque is lower than the undoing torque.
so you tighten wheel nuts that should be done up to 130nm to (your words not mine) as tight as my 1000nm air gun would do them and then tightened them some more with a bar, yer right course you did.Have you any idea how tight 1000nm or even 500nm as you now THINK your gun is actualy putting out actually is, i very much doubt you do.
And while were on the subject of air guns what make and model is yours and how old is it?
Are you sure your not mixing up undoing torque with doing up torque cos all the guns i have the doing up torque is lower than the undoing torque.
