Can anybody point me to a guide for wiring an abs sensor directly into the ecu?

Apparently with the new ones they are to be wired straight in and not to the connector under the bonnet.

Some day i might get rid of my 3 amigos :doh::doh::doh:

Actually i think i found it.

http://www.landroverclubvi.com/uploads/2/3/9/8/2398536/abs_sensor_overlay_harness.pdf

Why would u do that? Mine was originally with the sensors wired directly into the ECU(front and rear) and i cut them to put connectors. It's a false issue that the connectors will make problems, and even if it's so it can be fixed with a contact spray.... the most common problems are generated by sensor internal failure or phisical damage due to debris in the hub, and quite often the wiring gets damaged near the sensor cos there is exposed to all kind of risks... nothing hurts the wiring in the engine bay....do you want to go untill the ECU from the rear ones too?... cos that will be real fun, and those plugs are more exposed.
Then everytime u want to replace the sensor u have to route the wiring untill the ECU's plug...and if u buy a new hub it will come equipped with a sensor with plug.... believe me u will just make your life harder....if u believe that it's a bad contact give it a spray and that's all... IMO of course