ratty
I'm not special I'm limited edition
unspool the entire cable and cover the spool with lashings of engine oil. Wind in the first layer and then cover that in oil. Repeat until the entire cable is wound back in. Dont forget to oil the eyelet and crimp well too.
TheVengefulElephant
Well-Known Member
I'm assuming you mean unused oil?
ratty
I'm not special I'm limited edition
ratty
I'm not special I'm limited edition
dont always work - duz it Ratty - or is it a case of "do as I say - not as i do"?
I dint say to oil his solonoids did I?
Just to make daft feel better........
If yer has a waterproof solonoid pack it aint waterproof. Pull the fooker apart and sling some silicoon in the joints cos when the water drains back out it leaves the mud behind and if you let yer ballast drive yer winch don't work after.
appy now?
ratty
I'm not special I'm limited edition
hee hee - i dont fink she was winchin tho.
an stick some vaseline inside the soilinoid anorl - in fact iz good stuff to pack in any electrical joint that is likely to get wet.
an stick some vaseline inside the soilinoid anorl - in fact iz good stuff to pack in any electrical joint that is likely to get wet.
ratty
I'm not special I'm limited edition
hee hee - i dont fink she was winchin tho.
an stick some vaseline inside the soilinoid anorl - in fact iz good stuff to pack in any electrical joint that is likely to get wet.
I'll get gripsbabes to pack you with vaseline if yer aint carefull.
Do you wannanuver limp?
ratty
I'm not special I'm limited edition
err - Ratty - that aint how you spell lift
err - no - but it's what yer be doing after yer offroad walk.
ratty
I'm not special I'm limited edition
Aye, anywun needing vaseline in the next week, jest git Heffalump ter fart on yer winch.......................d'yer know, even I wish I dint jest say that.
Did your vibrating butt plug leave a residue then?
90boy
Well-Known Member
