cheongthong
Active Member
is that part nr 3911170939 that it should no been more that £ 100 do a search on the net is that part nr 3911170939 that it should no been more that £ 100 do a search on the net
That part number does not compute at Land rover what part are you on about. Eccentric arm is STC4608.
cheongthong
Active Member
LandyZone - Land Rover Forum ASSEMBLEY DEPRESSION CONTROL RANGE ROVER 95-02 - STC2806
this cost less that 20 £ ex shipping cost 3911170939 part if i am right ..you can send a message to or check this out
https://www.inlinefilters.co.uk
this cost less that 20 £ ex shipping cost 3911170939 part if i am right ..you can send a message to or check this out
https://www.inlinefilters.co.uk
Yes but it's not the same thing.
cheongthong
Active Member
sorry hier is the nr
:bounce:http://euroauto.ru/?option=com_retaillist&task=partinfo&nr=3366025&ah=1
:bounce:http://euroauto.ru/?option=com_retaillist&task=partinfo&nr=3366025&ah=1
Last edited:
No worky. Your item is listed as an inline filter quite different to a depression control valve.
Says page does not exist.
cheongthong
Active Member
see..... that a secondhand ( used part ) the new one you can order from ex transport cost
https://www.inlinefilters.co.uk
https://www.inlinefilters.co.uk
Rallymantony
Active Member
Sorry to dig up and old tread guys but I'm just trying to research this now, is it possible to change the old system rocker cover with a later one? I have a newer type rocker cover (the one with just the hose) sitting on a spares engine with blown head gasket, I need to replace the rocker gasket on my car anyway. Reason I ask is that the breather is cracked plus the grommets are missing. Thank you
RangeRoller dt
Well-Sprung Member
Cam cover maybe?
If yes - there’s a load of screws inside holding a plate with a mesh filter in there - you will see a difference from cleaning this out. I used petrol.
Ensure correct Untightening/tightening procedure and torque of bolts. Some use a little RTV to hold gasket in place for fitment as can be tight around the bulkhead.
Whatever it is - once you take it off you will have side by side comparison With other unit to check for fitment compatibility
If yes - there’s a load of screws inside holding a plate with a mesh filter in there - you will see a difference from cleaning this out. I used petrol.
Ensure correct Untightening/tightening procedure and torque of bolts. Some use a little RTV to hold gasket in place for fitment as can be tight around the bulkhead.
Whatever it is - once you take it off you will have side by side comparison With other unit to check for fitment compatibility
