i have bin told that you can put a marigold glove around distributor to make it water tight while going offroading just wondering does the distributer get hot and will this method cock anything else up cheers ..............
Shouldnt effect the heat of it at all, not sure its gonna make a lot of difference to the wet performance either, keep top quality leads on it, you can probably get a proper fitting purpose made boot to fit over it
You will need something on the coil too. But a liberal coating of WD40 before and after would probably be a good barrier as any. Unless you like the look of a condom pulled over parts of your ignition system
Where's a good place to get decent HT leads with extra insulation? Funnily enough my coil's usually **** wet through and never gives any bother but a bit of damp on the leads and it plays up...
Its water getting inside the dizzy thats the main problem anything that stops it is good. when I trialed a series 2a petrol I just plastered the dizzy with vaseline,messy but worked well.
I used an old plastic pop bottle,cut it down and slotted it over the dizzy then sealed any gaps with electrical tape,and did the same for the coil.
It still keeps running on all cylinders with the water level over the bonnet.....and it's a V8!