J

Jonhill0862

New Member

• Feb 6, 2012

• #1

Yesterday morning I was changing the glow plugs on the rangerover p38 (2.5 voice manual) , and all went well until I noticed a small water leak on the cylinder head upon further inspection the hose and connection were burst the connection is the one closest to the bulk head so any help would be most helpful a don't know where to start looking To find a new connection piece it's ribbed on one end that the hose connects to and small ribs on the end that goes into the head

 

Datatek

Well-Known Member

• Feb 6, 2012

• #2

Do you mean it has frozen and split? Or just come out of the head??

 

J

Jonhill0862

New Member

• Feb 6, 2012

• #3

Split and came out of head but not frozen ! It looks like it has been pressed into the head or hammered in !

 

wammers

No longer with us, RIP

Donater

• Feb 6, 2012

• #4

Outlet stubs are cryogenically inserted. Stub is frozen head is warmed. Then stub inserted. If you can get a suitalby sized stub made up there are products available to stick it in with.

 

J

Jonhill0862

New Member

• Feb 6, 2012

• #5

so this isn't a part a can get from LR and a would have to get it done myself what products are you meaning to use to glue the new part back in with ??

 

wammers

No longer with us, RIP

Donater

• Feb 6, 2012

• #6

Jonhill0862 said:

so this isn't a part a can get from LR and a would have to get it done myself what products are you meaning to use to glue the new part back in with ??

Click to expand...

Two part high temp Epoxy such as JB weld is one, products from Loctite will also do it for you.

 

Last edited: Feb 6, 2012