C

Celtic

New Member

• Jan 16, 2010

• #1

Hi all
what is the best way of getting upper link ball joint off the axle mounting,split pin out nut and washer removed,but the ball joint splitters i have are to small.
Any help most welcome.

 

G

gegs88

New Member

• Jan 16, 2010

• #2

a hammer each side of the outer housing where the taper is and a bloody good belt on each side with each hammer at the same time. usually works a treat

 

hughesy

Well-Known Member

• Jan 16, 2010

• #3

Usually comes out easy once the nut is off. The fun hasn't started yet though.

 

C

Celtic

New Member

• Jan 16, 2010

• #4

cheers guys,give it a good belt each side with hammers sounds good to me,give it a go in the morning if its not ****ing down or minus 10.