Bemmy
Active Member
Hi,
I'm about to fit a new Thrust washer(FTC 56) to a new Stub axle on my discovery 300tdi Auto.
Is it a case of pressing the new one onto the stub axle? Would this be possible with a vice or is a press required?
I'd like to keep the old stub axle, as it's only the thrust washer that's u/s, could I chisel the old one off?
Many thanks
Bemmy
I'm about to fit a new Thrust washer(FTC 56) to a new Stub axle on my discovery 300tdi Auto.
Is it a case of pressing the new one onto the stub axle? Would this be possible with a vice or is a press required?
I'd like to keep the old stub axle, as it's only the thrust washer that's u/s, could I chisel the old one off?
Many thanks
Bemmy
