Hi All,

So I had to renew a height sensor on my Disco, has anyone a simple thicko guide to how to do the nanocom part of the replacement, calibration, what should be checked??

Plus my nanocmom keeps showing that the ECU is not working.

Cheers

you can't do anything as long as you can't communicate with the ECU, connect nanocom, put ignition on wait a bit then try to access the ECU, does it communicate with other ECUs?... if only the sensor was the fault and you disconnecte the battery before replacement usually there's no need for calibration, though not in 100% of cases... better register to nanocom forum with that