sierrafery
Well-Known Member
I seriously doubt that
well after plugging everything back in i still have the srs light on
wondering where to go from here
wonder if
broken wire somewhere
faulty impact sensor
clock spring
just don't know what to do , in how i know the airbags i've fitted are sound, got them from a reputable breakers
wondering if i may have to take the 2 x curtain airbags out, seat airbag , impact sensors and get them sent away , it can see some serious money here
wondering where to go from here
wonder if
broken wire somewhere
faulty impact sensor
clock spring
just don't know what to do , in how i know the airbags i've fitted are sound, got them from a reputable breakers
wondering if i may have to take the 2 x curtain airbags out, seat airbag , impact sensors and get them sent away , it can see some serious money here
yes cleared all the codes , also with the diagnostics i reset the srs ecu to normal service condition
am abit lost , can see me checking every wire in the loom
Jonnyb1990
Well-Known Member
probs the base sensor in the seat, think its to do with the connector to the seat harness
thought i would put up the old and new codes
looking at them , 2 x have gone, being me replacing the curtain airbags
so left with one
got the 3 x impact sensors
steering wheel air bag
clock spring
have a spare seat air bag so going to disconnect the battery , wait then plug it into the seat connector plug, to eliminate the seat air bag
know it's on the drivers side , think i've got to step back and try and rethink this
if anyone may know would be over the moon please ,
thks in advance
looking at them , 2 x have gone, being me replacing the curtain airbags
so left with one
got the 3 x impact sensors
steering wheel air bag
clock spring
have a spare seat air bag so going to disconnect the battery , wait then plug it into the seat connector plug, to eliminate the seat air bag
know it's on the drivers side , think i've got to step back and try and rethink this
if anyone may know would be over the moon please ,
thks in advance
Jonnyb1990
Well-Known Member
Anything else not work ? ie horn
Rare for the airbag to throw up issues
Rare for the airbag to throw up issues
thks ,
horn works fine
wondering if the impact sensors can fail ,
have got a spare seat airbag so wondering about plugging that in
just driving me nuts and running out of time before the mot expires
just don't know really where to go next
wish i could put it into a garage but can't afford it
sierrafery
Well-Known Member
Ye, IMO the airbag module is at fault
thks
know it's a nightmare to get the srs ecu out
the diagnostics i've got resets it to service condition, but know some need to be cleared by a specialist company
heard that u have to replace them at a cost over around £400 quid
learnt a lot about the srs system,
wonder if i will have to get a specialist airbag company in, trouble is it may go into a lot of money
main goal would be just to find out what the fault is, then go from there if it's an expensive part
keep wondering about the impact sensors, if they actually fail etc
thks again
sierrafery
Well-Known Member
Try with this http://www.ebay.co.uk/itm/LANDROVER...S-0-25W-2-AMP-FUSED-FAULT-LIGHT-/261532676291 if the light goes away with it you know it's the airbag at fault
brilliant, thks for that
going to test my clock spring and impact sensors tomorrow, also swap over the seat airbag
just in case they fitted a new steering wheel airbag without replacing the clock spring
if the fault is still there will order some of these,
nothing like a challenge , lol
thks again
sierrafery
Well-Known Member
Don't mess with multimeter in the air bag's plug cos it sends voltage for continuity and it's dangerous... it should have a shorting pin in the plug exactly to avoid that
sorry my fault, only tested the clock spring, wouldn't dare use a multimeter on the steering wheel airbag
looking at this pic, i put the leads in each connector and got continuity across them
also got continuity from one plug to the other
made sure i removed the clock spring and tested it on the kitchen work top so it was disconnected from the landy
