meego

Well-Known Member

• Apr 17, 2016

• #1

Whats the score when changing these? I have a little bit of vertical play in these. They look like they need to be pressed out and in. Has anyone any advice?

 

johnlad

Well-Known Member

• Apr 18, 2016

• #2

can be done in situ using something like this
http://www.ebay.co.uk/itm/191836946084?_trksid=p2060353.m1438.l2649&ssPageName=STRK:MEBIDX:IT
not the easiest job getting the old ones out, its a bit easier pressing the new ones in, use genuine Lemforder replacements as its not a job you will want to do again

 

neilly

Well-Known Member

• Apr 18, 2016

• #3

Previous posts on this topic, suggested that some of the cheaper ball joint press tools could distort / bend.
the consensus was that the kennedy unit was made of better quality steel and worth the difference, have not used one myself, but when I do I will get this one, funnily enough it is cheaper on fleabay than direct from Cromwell tools.
http://www.ebay.co.uk/itm/131110401906?_trksid=p2055119.m1438.l2649&ssPageName=STRK:MEBIDX:IT


Cheers

 

Landmark2

Well-Known Member

• Apr 18, 2016

• #4

Hi, See if you can view this "How To" http://www.thed2boysclub.co.uk/viewtopic.php?f=5&t=2751
HTH,
Griff

 

wammers

No longer with us, RIP

Donater

• Apr 18, 2016

• #5

Vertical play means bottom joint is worn. See RAVE for instructions.

 

meego

Well-Known Member

• Apr 18, 2016

• #6

Thanks for the replies guys. I will get one of the tools mentioned and see how it goes. Already checked Rave Wammers and that's where I seen LR tool. Just have to get in about it and see what happens. Cheers again.