tottot said:

Re my post above, when trying to sort my starting issue I made up a little jumper cable and plugged one end into the brown live feed [ at relay position] and touched the other end on the white/red to solenoid. Started every time.
Connected small white from ignition switch through a test bulb to the earth [ earth can be tested by connecting bulb brown to black]
This proved there was no power in small white when key turned. I changed ignition unit but this did not help.
This proved issue is/was in the white cable. I did not want to waste time sorting that so.
My fix was to run a cable direct from the white wire position on ignition switch to the starter solenoid. It only needs some 5amp to activate starter solenoid.
Why there is a relay for this job I cant think. Older cars have direct line from ignition to starter method.

Click to expand...

Hicap phill said:

Hope this helps

Ignition off
Brown live 12b
Brown/red 0
Black 0
White/red 0

Start up(12v)
Brown live
Brown/red live
Red/white live
Black 0

Ignition off..
Jump across brown + white/red
Engine will turn over

Ignition on..
same as above but engine will run

Just confirmed the above,standard 4 post relay

Click to expand...

Hicap phill said:

Is the clickeing the glow plug relay? Or is yours under the bonnet

Nothing else clicks near my fuse box(early glass fuse type)

Click to expand...

patrickr90 said:

Thanks for this. Totally clarifies what should be happening. Mine's slightly different in that the Brown/Red is white in my case. I think my relay has 5 terminals but the one in the middle doesn't seem to have a connecting cable.

Click to expand...