Wicks also sell wood saws and measuring tools
Is easy to do yourself
6mm ply for sides and roof and 12mmor thicker ply for the floor. I put in a full bulkhead in behind the front seats too.I used the foam u buy for under laminate floor for under the ply and it keeps it warm, dry (no condensation) and is quieter.
Silicon seal the joints and then varnish it to make it waterproof
6mm ply for sides and roof and 12mmor thicker ply for the floor. I put in a full bulkhead in behind the front seats too.I used the foam u buy for under laminate floor for under the ply and it keeps it warm, dry (no condensation) and is quieter.
Silicon seal the joints and then varnish it to make it waterproof
wiltshire landyman
I’m back
template the ply or use a scribing bar,piece of ****s.done 3 vw transporters sides and floors and bulkhead this way
90truckcab
Well-Known Member
its too easy for some people, prob only take a day measure it all up carefully, cut it out of 6mm for sides and 12 - 18 or even 22 for the floor and top of arches, either fix with self drilling tek screws or rivits, yer can get a good 12mm insulation behind it too
arboorman
Active Member
This might be worth a look, not sure if they do a kit for a 90 though?
Land Rover Defender 110 hard top full ply lining kit on eBay (end time 02-Jan-10 08:56:26 GMT)
Home
Land Rover Defender 110 hard top full ply lining kit on eBay (end time 02-Jan-10 08:56:26 GMT)
Home
Trewey
Cockernee, Pasty munchin bastid.
Mine cost me about £30 and took about half a day.
I made it so there's nothing actually fixed to the vehicle - no drilling of the vehicle structure.
It's in sections that interlock. The frontmost sections remove, depending whether the 2nd row seats are up or down.
Seats down
Seats up
I made it so there's nothing actually fixed to the vehicle - no drilling of the vehicle structure.
It's in sections that interlock. The frontmost sections remove, depending whether the 2nd row seats are up or down.
Seats down
Seats up
landy10
New Member
hughesy
Well-Known Member
Oh yeah forgot. 250 quid seems like a bargain thenAint 110 a bit more of a rectangle
90truckcab
Well-Known Member
Trewey
Cockernee, Pasty munchin bastid.
:multiply:
jamescronin
Active Member
Although £250 is step a sheet on proper birch ply is a good 40-50 quid these days (depending on where you get it from) - well it was when i built a load of huge speaker cabs a couple of years back out of 18mm - standard WPB is much cheeper but not as durable.
Just depends what you want to do with it........... (and if you plan on submersing it in water all the time)
Just depends what you want to do with it........... (and if you plan on submersing it in water all the time)
