DAZROBBO

DAZROBBO

New Member
I have a disco 200. I have lifted suspention by 4inch, also fited a ajustable pinard rod. having problems seting it to corect length. Can any one give any tips on how to set pinard rod up ????
 
I assume yu mean panhard! Rod???

When yu lifted it you pulled the axle offcentre. You adjust the rod so that it Pushes the axle back to the centre of the vehicle?? Or put simply check your wheels are equal distance from centre.
 
Panhard rod centres the axle in the chassis.
Choose a datum point on the axle and measure the distance to the chassis rails on each side. Adjust panhard rod to make measurements equal.
 
Trewey said:
Panhard rod centres the axle in the chassis.
Choose a datum point on the axle and measure the distance to the chassis rails on each side. Adjust panhard rod to make measurements equal.
Click to expand...

jamesmartin said:
panhard rod ,adjust till axle/wheels are centered with vehicle when not supported with jacks
Click to expand...


Keep up FFS!! :D Am sure yu two just post to keep ya post count up :p :p
 
You will need to set the panhard rod about 4 or 5 mm longer than the standard rod.

Cheers
 
Aaaah , spoilsports ! Its so much more fun driving without one ....like one of those off-centre wheeled bikes clowns have ........
 
You must log in or register to reply here.

Similar threads

S
Panhard rod
Replies
7
Views
1K
Hicap phill
H
K
Disco 2 steering wheel is centralized
Replies
1
Views
767
discool
discool
L
My series 3 and an engine swap question
Replies
1
Views
197
BIGrabbit100
B
pabloako
Length of accelerator push/control rod (Series 2)
Replies
4
Views
1K
pabloako
pabloako
G
Clutch slave cylinder rod
Replies
4
Views
1K
Greger911
G