rayd01

New Member

• Mar 2, 2021

• #1

hi i have a 2000 p38a which i have brought back from the dead but i cannot get the heating to work the heater matrix has been flushed and appears to be circulating water i would be grateful for any info on what to do

 

brianp38dse

Well-Known Member

• Mar 2, 2021

• #2

Hello and welcome
Best to ask over in the range rover section of the forumhttps://www.landyzone.co.uk/forum/range-rover.10/

 

saxavordian

Well-Known Member

• Mar 2, 2021

• #3

 

biketeacherdave

Well-Known Member

• Mar 2, 2021

• #4

I know you say you have flushed the heater matrix so the best way to get the coolant flowing threw it is to pull 1 of the heater matrix hoses when the engines running and connect it to a hose with gentle flow then block it off at the engine side remove the header tank cap and let it over flow..................hope that makes sense works for me every time.
Good luck.

 

kermit_rr

Very

Full Member

• Mar 2, 2021

• #5

Hi there and welcome
Probably the blend motors are stuck on cold, if the book symbol is showing

 

Hippo

Lord Hippo

• Mar 8, 2021

• #6

Welcome to the forum