Afternoon,

The car wash made off with my rear door rubbing strip! I got it back, but need to fix it back on properly.
I've noticed that one of the holes in the door is missing the blue grommet, so the clip isn't staying in:


Anyone know where I can get one of these from? Or any alternative methods to getting the clips to stay in?
Looks like the previous owner had the same problem, there was sealant all over the place:


Thanks

Yours look slightly modified.
I have never taken 1 off or lost 1 but have a look at this.



But it looks like the rear end should be attached with a bolt from the inside. Not the "bonded" on bolt you show.

J

marjon said:

Yours look slightly modified.
I have never taken 1 off or lost 1 but have a look at this.

Lrcat

Genuine Land Rover Cupsac - BTR691 | Rimmer Bros

Order your Cupsac Clip - BTR691 - Genuine ⛽ Low prices and fast, worldwide delivery ✈ British car experts ♚ Call ☎ 01522 568000 or ☎ 1-855-746-2767

rimmerbros.com

But it looks like the rear end should be attached with a bolt from the inside. Not the "bonded" on bolt you show.

J

Click to expand...

The lower one has a screw in the door the upper is held with the pin and sac cup. I am not sure if there is a screw in the front of the door, mine is just clip on with the above fittings. I have some in my spares boxes just in case