Datatek
Well-Known Member
See pwood999's post.
Last edited:
@MontyChambers did you do the Nanocom check (not while driving) on the two inputs ? No point in replacing the switch unless you're sure it's broke !!
The RAVE procedure had a missing bit between 7 & 8. It should be:
7. Extend switch plunger fully.
7a. Hold brake pedal down.
8. Fit switch & then release brake pedal.
That way the pedal sets the plunger correctly when you release the pedal.
The RAVE procedure had a missing bit between 7 & 8. It should be:
7. Extend switch plunger fully.
7a. Hold brake pedal down.
8. Fit switch & then release brake pedal.
That way the pedal sets the plunger correctly when you release the pedal.
Datatek
Well-Known Member
Ah good, you have corrected me.
MontyChambers
Member
Very helpful, tomorrow mornings job, by the way nanocom is running as it should, Hope for clear sky's tomorrow, metaphorically as well as weather-wise!
